Knock Sensor Replacement - Bank 1 (LGX)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Knock Sensor - Bank 1 (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove Front Wheelhouse Liner-Right Side. Refer to Front Wheelhouse Liner Replacement (Non V-Series) Remove Front Compartment Lower Noise Shield. Refer to Front Compartment Lower Noise Shield Replacement (Front Wheel Drive)Front Compartment Lower Noise Shield Replacement (All Wheel Drive)
1	Electrical Connector
2	Knock Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft)
3	Knock Sensor