Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the evaporative emission canister purge pipe (3) to the EVAP emission canister. Refer to Plastic Collar Quick Connect Fitting Service .
- Install the evaporative emission canister purge pipe (3) to the retainers (2).
- Install NEW tie straps (1) to attach the evaporative emission canister purge pipe to the fuel tank filler pipe.
- Install the right rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement (Non V-Series)Rear Wheelhouse Liner Replacement (V-Series) .
- Connect the evaporative emission canister purge pipe (1) to the fuel tank vent valve hose. Refer to Plastic Collar Quick Connect Fitting Service .
- Lower the vehicle.