Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install Camshaft Position Sensor (2)
- Install and tighten Camshaft Position Sensor Bolt (1) to 10 N.m (89 lb in).
- Connect Camshaft Position Sensor Electrical Connector (1) @ Camshaft Position Sensor (2)
- Install Camshaft Housing Cover Insulator - Right Side. Refer to Camshaft Housing Cover Insulator Replacement - Right Side
NOTE:
Always install the camshaft position sensor O-ring (3) supplied with the NEW camshaft position sensor. If reinstalling the sensor, inspect the camshaft position sensor O-ring (3) and replace as necessary. Lubricate the camshaft position sensor O-ring (3) with clean engine oil prior to installing the camshaft position sensor.
CAUTION:
Refer to Fastener Caution .