Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake (LGX)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Actuator Solenoid Valve Solenoid - Bank 2 (Left Side) Intake (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove Intake Manifold Cover. Refer to Intake Manifold Cover Replacement (LGX)
1	Electrical Connector
2	Camshaft Position Actuator Solenoid Valve Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
3	Camshaft Position Actuator Solenoid Valve
4	O-Ring NOTE: Install a NEW O-ring seal. NOTE: Lubricate the NEW O-ring seals with clean engine oil.
5	Camshaft Position Actuator Solenoid Valve Seal NOTE: Always install the camshaft position actuator solenoid valve seal supplied with the NEW camshaft position actuator solenoid valve. If reinstalling the valve, inspect the camshaft position actuator solenoid valve seal and replace as necessary.