Engine Mount Bracket Replacement - Right Side (LGX - RWD)

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Mount Bracket - Right Side (LGX - RWD)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Drivetrain and Front Suspension Frame Removal and Installation (LGX, LTG) Catalytic Converter Replacement - Right Side (LGX)
1	Engine Mount Bracket Fastener (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 58 N.m (43 lb ft)
2	Engine Mount Bracket NOTE: Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket includes pressed on spacers on the back side. Even though it is highly unlikely, the pressed on spacers may loosen and fall off during engine mount bracket removal. Ensure the spacers are in place before reinstalling an existing bracket.

Callout

Component Name

Preliminary Procedures

Drivetrain and Front Suspension Frame Removal and Installation (LGX, LTG)
Catalytic Converter Replacement - Right Side (LGX)

Engine Mount Bracket Fastener (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
58 N.m (43 lb ft)

Engine Mount Bracket

NOTE:

Engine mount brackets are magnesium. To prevent galvanic corrosion, the bracket includes pressed on spacers on the back side. Even though it is highly unlikely, the pressed on spacers may loosen and fall off during engine mount bracket removal. Ensure the spacers are in place before reinstalling an existing bracket.