Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the flywheel (1) to the crankshaft.
- Install and hand tighten the NEW flywheel bolts (2).
- Install the EN-46106 and bolts.
- Tighten the flywheel bolts (1).
- Tighten the bolts (1-8) a first pass in sequence to 30 N.m (22 lb ft).
- Tighten the bolts (1-8) a final pass in sequence an additional 60 degrees using EN-45059 .
- Remove the EN-46106 .
- Install the clutch assembly. Clutch Assembly Replacement (M3L Transmission)
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
NOTE:
The flywheel does not use a locating pins for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flywheel bolts.
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
CAUTION:
Refer to Fastener Caution .