Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the cylinder head as necessary. Cylinder Head Assemble (LGX)
- Ensure the cylinder head locating pins (5) are securely mounted in the cylinder block deck face.
- Install a NEW right cylinder head gasket (4) using the deck face locating pins for retention.
- Install Cylinder Head Assembly (3) - Cylinder Head Installation - Right Side (LGX)
- Install Valve Lifter (1, 2) -Right side - Valve Lifter Replacement - Right Side (LGX)
- Install Camshaft Carrier- Right Side (2) - Camshaft Carrier Installation - Right Side
- Install Camshaft-Right Side - Camshaft Installation - Right Side (LGX)
- Position wire harness and connect as necessary.
- Install ground wire and ground wire bolt. Tighten bolt to 15 N.m (11 lb ft).
- Install Fuel Pump - Fuel Pump Replacement (LGX)
- Install Warm Up Three-Way Catalytic Converter (3) @Bank 1- Catalytic Converter Replacement - Right Side (LGX)
- Install Fuel Injection Fuel Rail Noise Shield (1) - Fuel Injection Fuel Rail Noise Shield Replacement
- Install Camshaft Timing Chain-Right Side - Camshaft Timing Chain Assembly Replacement - Right Side (LGX)
CAUTION:
Refer to Fastener Caution .