Rocker Panel Molding Replacement (Coupe)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rocker Panel Molding (Coupe)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the tires and wheels on the side the rocker panel will be serviced. Refer to Tire and Wheel Removal and Installation (Non V-Series)Tire and Wheel Removal and Installation (V-Series October 4th 2015 and Earlier)Tire and Wheel Removal and Installation (V-Series October 5th 2015 and Later) . Remove the rear tire front air deflector. Refer to Rear Tire Front Air Deflector Replacement . Open the door on the side the rocker panel will be serviced.
1	Wheelhouse Panel Liner Push-in Retainer (Qty: 3)
2	Rocker Panel Molding Retainer (Qty: 6)
3	Rocker Panel Molding Retainer (Qty: 2)
4	Rocker Panel Molding Retainer (Qty: 7)
5	Rocker Panel Molding Retainer (Qty: 7)
6	Rocker Panel Molding Procedure Begin at the bottom of the rocker molding, release the six vertical lower retainers from the rocker panel. Release the two forward vertical retainers from the rocker outer panel. Release the seven upper horizontal retainers from the body side. Release the seven vertical retainers from the rocker outer panel. Replace any broken retainers as necessary.