Circuit/System Verification
Remove all metal objects from the charging pad before charging your mobile device. Metal objects, such as coins, keys, rings, or paper clips, between the phone and charging pad will become very hot. On the rare occasion that the charging system does not detect a metal object, and the object gets wedged between the phone and charger, remove the phone and allow the metallic object to cool before removing it from the charging pad, to prevent burns.
- Ignition On/Vehicle in Service Mode.
- Verify the charging pad is clear of any wireless device.
Verify the function:Wireless Charging Indicator<!--VAT7071345-->=Off<!--VAT6933-->
- If the indicator is On
Refer to: Circuit/System Testing
- If the indicator is Off
- If the indicator is On
- Install the special tool:<sptool><sptool-no>EL-51755</sptool-no><sptool-desc>Inductive Charging Test Tool</sptool-desc></sptool>@ Charging Pad/Pocket, keeping it centered.
Verify the function:Special Tools<!--Title-->LED (Light Emitting Diode)<!--VAT8449502-->=On<!--VAT6935-->
- If the special tool is Off
Refer to: Circuit/System Testing
- If the special tool is On
- If the special tool is Off
- Verify the function:Wireless Charging Indicator<!--VAT7071345-->=On<!--VAT6935-->
- If the indicator is Off
Refer to: Circuit/System Testing
- If the indicator is On
- If the indicator is Off
- All OK.
There is a charging coil located in the center of the Charging Pad/Pocket. The <sptool><sptool-no>EL-51755</sptool-no><sptool-desc>Inductive Charging Test Tool</sptool-desc></sptool> has a charging coil in the center of the tool. These coils must be aligned in order for the test tool to illuminate.
To complete successfully, the procedure may need to be repeated <p01> times.Between each attempt, remove the tool and wait <p01> s.
The customer's device may not be compatible or is defective.