LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Engine Controls And Fuel - 3.6L (LF4 LGX) - DTC P0685 LGX To DTC P3436 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P129D: Fuel Pump Driver Control Module Ignition On/Start Switch (LF4) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify DTC P0562 is not set.
    • If the DTC is not set 
  3. Verify the DTC P129D does not set.
    • If DTC P129D sets 

      Refer to Circuit/System Testing.

    • If DTC P129D does not set 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify DTC P129D does not set.
    • If DTC P129D sets 

      Refer to Circuit/System Testing.

    • If DTC P129D does not set 
  6. All OK.