LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Engine Controls And Fuel - 2.0L (LTG) Or 2.5L (LCV) - DTC P0010 To DTC P0324) >> Diagnostic Information and Procedures >> DTC P0011 or P0014: Camshaft Position System >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle Off, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 7-12 Ω between the control terminal 1 or A and the low reference circuit terminal 2 or B.
    • If not between 7-12 Ω 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If between 7-12 Ω 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If less than infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals