LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Engine Controls And Fuel - 2.0L (LTG) Or 2.5L (LCV) - DTC P0010 To DTC P0324) >> Diagnostic Information and Procedures >> DTC P0010, P0013, or P2088-P2091: Camshaft Position Actuator Solenoid Valve >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition On/Vehicle in Service Mode.
  2. Verify DTC P0335, P0336, P0340, or P0341 is not set.
    • If the DTC is not set 
  3. Engine Running.
  4. Verify the scan tool parameters listed below do not display Malfunction:
    • Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Open Test Status
    • Intake Camshaft Position Actuator Solenoid Valve Control Circuit Open Test Status
    • Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Test Status
    • Intake Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Test Status
    • Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Test Status
    • Intake Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing.

    • If Malfunction is not displayed 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals