LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B097B: Power Mode Start Switch >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the S38 Ignition Mode Switch.
  2. Test for 4.5-5.5 kΩ between the terminals listed below with the S38 Ignition Mode Switch released,
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 4.5-5.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 4.5-5.5 kΩ 
  3. Test for 1-1.5 kΩ between the terminals listed below with the S38 Ignition Mode Switch pressed.
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 1-1.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 1-1.5 kΩ 
  4. All OK.
scientia non olet · About LEMON Manuals