Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series)
- Drain the rear differential carrier assembly. Differential Oil Replacement (195mm Axle)
- Remove the propeller shaft. Two-Piece Propeller Shaft Replacement (LTG, LGX, LCV)
- Separate the rear wheel drive shafts from the differential carrier assembly. Rear Wheel Drive Shaft Replacement - Left Side (LCV, LF4) , Rear Wheel Drive Shaft Replacement - Right Side (LF4, LCV)
- Support the differential carrier assembly with a suitable hydraulic jack stand (1).
- Remove the differential carrier rear bolt and washer (2).
- Remove the 2 differential carrier front bolts (1).
- Using the hydraulic jack stand, lower and remove the differential carrier assembly (1).
NOTE:
It is not necessary to completely remove the wheel drive axles from the vehicle. Only separate the rear wheel drive shafts from the differential carrier assembly and not from the wheel bearing and hub assembly.