LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Electronic Suspension Front Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Base)Lifting and Jacking the Vehicle (V-Series) .
  2. Remove the front wheel house liner. Refer to Front Wheelhouse Liner Replacement (Non V-Series)Front Wheelhouse Liner Replacement (V-Series) .
    3. Fig 1: Electronic Level Sensor & Electrical Connector
    GM2868517Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connector (2) from the electronic level sensor (1).
    4. Fig 2: Level Sensor & Related Components
    GM2868527Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the level sensor link (2) from the lower control arm ball stud (1).
  5. Loosen the level sensor nut (4).
  6. Remove the level sensor (3) from the frame rail.
scientia non olet · About LEMON Manuals