LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 3.6L (LGX) - Repair Instructions >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

  1. Intake Manifold - Remove - Intake Manifold Replacement
  2. GM4316166

    Electrical Connector (1) - Disconnect

  3. Camshaft Position Actuator Solenoid Valve Bolt (2) - Remove
  4. GM4316184

    Camshaft Position Actuator Solenoid Valve (1) - Remove

  5. Inspect the camshaft position actuator solenoid valve O-ring (2) and replace as necessary.
    6. NOTE:
    • ALWAYS install the camshaft position actuator solenoid valve seal supplied with the NEW valve.
    • If reinstalling the camshaft position actuator solenoid valve, inspect the valve seal and replace as necessary.
  6. Camshaft Position Actuator Solenoid Valve Seal (3) - Remove and DISCARD
scientia non olet · About LEMON Manuals