Circuit/System Verification
- Ignition ON, observe the scan tool ECM - Fuel Level Sensor parameters. The reading should be between 0.5-3.5 V and vary with fuel level.
- Observe the scan tool Instrument Cluster Fuel Level Sensor parameter. The reading should be 0-100 percent and vary with fuel level.
- If the reading does not vary with fuel level, refer to Circuit/System Testing.
- Command the All Indicators test ON and OFF with the scan tool, verify that the low fuel level indicator turns ON and OFF.
- If the low fuel level indicator always stays on or always off, replace the P16 Instrument Cluster.