Oil Pump Disassemble
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | RemoveVacuum Pump Seal and DISCARD the seal. |
| 2 | Dowel Pin
NOTE:
This is press fit and not serviceable. |
| 3 | Remove Oil Pump Housing Passage Seal and DISCARD the seal. |
| 4 | Remove Oil Pump Housing Passage Seal and DISCARD the seal. |
| 5 | Remove Oil Pump Drive Bolt and DISCARD the bolt. |
| 6 | Oil Pump Sprocket |
| 7 | Oil Pump Suction Pipe Bolt |
| 8 | Oil Pump Suction Pipe |
| 9 | Remove Oil Pump Suction Pipe Gasket and DISCARD the gasket. |
| 10 | Oil Pump Flow Control Valve Bolt |
| 11 | Oil Pump Flow Control Valve
CAUTION:
After removing the oil pump flow control valve, ensure the entire valve has been removed and there is no debris left in the oil pump bore. Failure to ensure the oil pump bore is free from debris may result in engine damage. |