Transmission Control Replacement (With Base)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Transmission Control Assembly (With Base)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement Remove the left front floor console side trim panel. Refer to Front Floor Console Extension Panel Replacement - Left Side WARNING: After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury. Disconnect the range selector lever cable. Refer to Range Selector Lever Cable Replacement Disconnect the transmission control electrical connectors.
1	Transmission Control Fasteners (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft).
2	Transmission Control

Callout

Component Name

Preliminary Procedures

Remove the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement
Remove the left front floor console side trim panel. Refer to Front Floor Console Extension Panel Replacement - Left Side

WARNING:

After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

Disconnect the range selector lever cable. Refer to Range Selector Lever Cable Replacement
Disconnect the transmission control electrical connectors.

Transmission Control Fasteners (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
25 N.m (18 lb ft).

Transmission Control