Transmission Case Front Cover and Drive Link Installation
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Front Support Cover Gasket
NOTE:
Install a NEW gasket. |
| 2 | Drive Sprocket Thrust Washer (Rear) |
| 3 | Drive Sprocket |
| 4 | Drive Link Assembly |
| 5 | Drive Sprocket Thrust Washer (Front) |
| 6 | Automatic Transmission Front Cover Seal
NOTE:
Install a NEW seal. |
| 7 | Automatic Transmission Front Cover
NOTE:
Ensure the drive link assembly is not pinched by the front cover and moves freely on the drive sprocket. |
| 8 | Automatic Transmission Front Cover Bolt M6 x 30 (Qty: 11)
CAUTION:
Refer to Fastener Caution . Procedure
NOTE:
Use NEW bolts. Tighten the bolts in the sequence shown.
|