Removal Procedure
WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the transmission fluid filter (4). Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement (Rear Wheel Drive) Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement (All Wheel Drive) .
- Release the transmission control wiring harness connectors (1).
- Carefully disconnect the wiring harness clip (5) from the valve body.NOTE: If replacing the wiring harness, the new wiring harness may not have electrical connector (2). If it does not have electrical connector (2), the control valve body will have to be removed.
- If necessary, remove the control valve body from the transmission. Refer to Control Valve Body Replacement (M5N)
- If equipped, unlatch the connector retainer (3), then disconnect the main connector (2).
- Remove the transmission control wiring harness (4).
NOTE:
Mark and identify electrical connectors before removal to ensure correct installation.