LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2017 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Automatic Transmission - 8L45 (M5N M5T) Or 8L90 (M5U) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Wiring Harness Replacement (Electrical Connector Passage Sleeve) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the control valve body. Control Valve Body Replacement (M5U, M5T) Control Valve Body Replacement (M5N) .
  2. Disconnect the chassis wiring harness from the transmission electrical connector.
    3. Fig 1: Electrical Connector
    GM3802143Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connector (1).
    4. Fig 2: Retaining Tabs
    GM3802175Courtesy of GENERAL MOTORS COMPANY
  4. Using a flat-bladed tool, press inward the four retaining tabs (1) around the main connector, then slide the main connector (2) inward into the transmission case.
  5. Remove the automatic transmission wiring harness from the transmission.
scientia non olet · About LEMON Manuals