Transmission Case Front Cover and Drive Link Removal
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | A/Trans Front Cover Bolt M6 x 30 (Qty: 11)
NOTE:
DISCARD the bolts. |
| 2 | A/Trans Front Cover Procedure Use the GE-8433 puller bar and 2 bolts in the threaded holes of the front cover to remove it from the case. Special Tools GE-8433 Puller Bar For equivalent regional tools, refer to Special Tools . |
| 3 | A/Trans Front Cover Seal
NOTE:
DISCARD the seal. |
| 4 | Drive Sprocket Thrust Washer (Front) |
| 5 | Drive Sprocket |
| 6 | Drive Link Assembly |
| 7 | Drive Sprocket Thrust Washer (Rear) |
| 8 | A/Trans Front Support Cover Gasket
NOTE:
Remove and DISCARD the gasket. |