LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2017 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 240 (Automatic Transmission - 8L45 (M5N M5T) Or 8L90 (M5U) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the park brake.
  2. {If equipped} Remove Transmission Heat Shield. Refer to Transmission Heat Shield Replacement 
    3. Fig 1: Range Selector Lever Cable, Terminal, Shift Lever Pin And Retainer
    GM2787001Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the transmission range selector lever cable terminal (1) from the transmission manual shift lever pin (6).
  4. Slide the retainer (4) rearward to release the transmission range selector lever cable from the bracket.
  5. Remove Front Floor Lower Console. Refer to Front Floor Lower Console Replacement
    6. Fig 2: Cable Assembly
    GM2787003Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Mark the orientation of the grommet to the floor panel for installation.

  6. Remove the grommet and cable assembly (1) from the floor panel.
    7. Fig 3: Transmission Range Selector Lever Cable Retainer And Terminal
    GM2219111Courtesy of GENERAL MOTORS COMPANY
  7. Slide the transmission range selector lever cable retainer forward (1) and remove the transmission range selector cable from the transmission control base.
  8. Disconnect the transmission range selector lever cable terminal (2) from the shift lever pin.
  9. Remove the transmission range selector lever cable from the vehicle.
scientia non olet · About LEMON Manuals