LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2017 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Vehicle Diagnostic Information - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Diagnostic Repair Verification

Diagnostic Repair Verification

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

After a repair has been made, some DTCs require the ignition to be turned Off and then back On before the scan tool function will clear the DTC.

  1. Ignition/Vehicle Off.
  2. Install any components or connectors that have been removed or replaced during diagnosis.
  3. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  4. Ignition On/Vehicle in Service Mode.
  5. Clear the DTCs.
  6. Ignition/Vehicle Off for greater than <p01> s.
  7. Perform the Circuit/System Verification and verify the result ends with an All OK.&mdash;If available

    or<!--Generic, between 2 options-->

    If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set.If the DTC sets or another DTC is present » Refer to:Diagnostic Trouble Code (DTC) List - Vehicle 

    or<!--Generic, between 2 options-->

    If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair.If the customer concern reoccurs or another symptom is present » Refer to:Symptoms - Vehicle 

scientia non olet · About LEMON Manuals