Circuit/System Verification
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the transmission fluid level and condition is correct. Refer to Transmission Fluid Level and Condition Check .
- If the transmission fluid and condition is not correct
Repair as necessary.
- If the transmission fluid level and condition is correct
- If the transmission fluid and condition is not correct
- Ignition On, clear the DTCs from the K71 Transmission Control Module with a scan tool.
- Verify the transmission operation performs as indicated in the road test instructions and DTC P0746 or P0747 did not set. Refer to Road Test .
- If DTC P0746 or P0747 did set and the transmission does not shift correctly
Refer to Circuit/System Testing.
- If DTC P0746 or P0747 did not set and the transmission shifts correctly
- If DTC P0746 or P0747 did set and the transmission does not shift correctly
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.