LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2017 >> Acadia SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Automatic Transmission - 8L45 (M5N M5T) Or 8L90 (M5U) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0711-P0713: Transmission Fluid Temperature Sensor >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the Circuit/System Testing first.
  2. Ignition Off, remove the transmission fluid pan from the T12 Automatic Transmission Assembly.
  3. Disconnect the vehicle harness connector at X175.
  4. Remove the automatic transmission wiring harness electrical connector passage sleeve.
  5. Disconnect the transmission control wiring harness.
  6. Connector a jumper wire between X176 terminal 15 and terminal 16.
  7. Test for infinite resistance between X175 terminal 11 and ground.
    • If less than infinite resistance 

      Replace the automatic transmission wire harness electrical connector passage sleeve.

    • If infinite resistance 
  8. Test for less than 2 Ω between X175 terminal 11 and terminal 12.
    • If 2 Ω or greater 

      Replace the automatic transmission wire harness electrical connector passage sleeve.

    • If less than 2 Ω 
    9. NOTE:

    The B13 Transmission Fluid Temperature Sensor is part of the transmission control wiring harness assembly.

  9. Replace the B13 Transmission Fluid Temperature Sensor.
scientia non olet · About LEMON Manuals