Electronic Suspension Control Module Replacement (LGX)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electronic Suspension Control Module (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the left rear compartment side trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side (Sedan with AM9)Rear Compartment Side Trim Replacement - Left Side (Sedan except AM9)Rear Compartment Side Trim Replacement - Left Side (Coupe) .
1	Electronic Suspension Control Module Electrical Connector Procedure Release the lock tab on the electrical connector and remove.
2	Electronic Suspension Control Module Procedure Release the lock tabs and remove the control module from the mounting bracket. Reprogram the control module. Refer to Electronic Suspension Control Module Programming and Setup .

Callout

Component Name

Preliminary Procedure
Remove the left rear compartment side trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side (Sedan with AM9)Rear Compartment Side Trim Replacement - Left Side (Sedan except AM9)Rear Compartment Side Trim Replacement - Left Side (Coupe) .

Electronic Suspension Control Module Electrical Connector
Procedure
Release the lock tab on the electrical connector and remove.

Electronic Suspension Control Module

Procedure

Release the lock tabs and remove the control module from the mounting bracket.
Reprogram the control module. Refer to Electronic Suspension Control Module Programming and Setup .