Turbine Shaft Fluid Seal Ring Installation

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turbine Shaft Fluid Seal Ring

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Turbine Shaft Fluid Seal Ring (Qty: 4) CAUTION: Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage. CAUTION: Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage. Procedure Adjust the turn screw on DT-51088-3 seal protector and install the bottom seal ring first. Use the large taper side of DT-51088-1 seal sizer for initial seal sizing, then flip the tool over for final sizing. Special Tools DT-51088 Seal Installer For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Turbine Shaft Fluid Seal Ring (Qty: 4)

CAUTION:

Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

CAUTION:

Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

Procedure

Adjust the turn screw on DT-51088-3 seal protector and install the bottom seal ring first.
Use the large taper side of DT-51088-1 seal sizer for initial seal sizing, then flip the tool over for final sizing.

Special Tools
DT-51088 Seal Installer
For equivalent regional tools, refer to Special Tools .

Fig 1: Turbine Shaft Fluid Seal Ring

Courtesy of GENERAL MOTORS COMPANY

Turbine Shaft Fluid Seal Ring Installation

Callout	Component Name
1	Turbine Shaft Fluid Seal Ring (Qty: 3) CAUTION: Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage. CAUTION: Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage. Procedure Adjust the turn screw on DT-50911-3 seal protector and install the bottom seal ring first. Use the large taper side of DT-50911-1 seal sizer for initial seal sizing, then flip the tool over for final sizing. Special Tools DT-50911 Seal Installer For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Turbine Shaft Fluid Seal Ring (Qty: 3)

CAUTION:

Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

CAUTION:

Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

Procedure

Adjust the turn screw on DT-50911-3 seal protector and install the bottom seal ring first.
Use the large taper side of DT-50911-1 seal sizer for initial seal sizing, then flip the tool over for final sizing.

Special Tools
DT-50911 Seal Installer
For equivalent regional tools, refer to Special Tools .