Fastener Specifications (On Vehicle)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Single Use Non-Threaded Fasteners/Components

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application
Manual Shaft Shift Pin
Manual Shift Shaft Seal
Torque Converter Fluid Seal

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English), 5km/h (3MPH)
Input Speed Sensor Wiring Harness Bolt
First Pass:	4 N.m (35 lb in)
Final Pass:	45 Degrees
Output Speed Sensor Wiring Harness Bolt
First Pass:	4 N.m (35 lb in)
Final Pass:	45 Degrees
Torque Converter Bolts	63 N.m (46 lb ft)
Transmission Fluid Baffle Bolts
First Pass:	4 N.m (35 lb in)
Final Pass:	45 Degrees

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English), 5km/h (3MPH)
Automatic Transmission Auxiliary Fluid Accumulator Bolt	8 N.m (71 lb in)
Automatic Transmission Control Indicator Screws	2.5 N.m (22 lb in)
Automatic Transmission Range Selector Lever	25 N.m (18 lb ft)
Auxiliary Heater Pump Bracket to the Transmission	10 N.m (89 lb in)
Flywheel Inspection Cover/Converter Cover Fasteners	10 N.m (89 lb in)
Oil Pressure Test Plug	11 N.m (97 lb in)
Propeller Shaft Transmission Flange Nut	105 N.m (77 lb ft)
Range Selector Lever Cable Bracket	22 N.m (16 lb ft)
Transmission Control Fasteners	9 N.m (80 lb in)
Transmission Fluid Pan Fasteners	10 N.m (89 lb in)
Transmission Heat Shield Fasteners	9 N.m (80 lb in)
Transmission to Engine Bolts	58 N.m (43 lb ft)
Valve Body Assembly Bolts (1, 2) (1 - M6 x 68) and Bolts (2 - M6 x 45)	9 N.m (80 lb in)