LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 3.6L (LFX) - DTC P0351 To P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P05CC-P05CF: Cold Start Intake Camshaft Position System Performance Bank >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition Off, disconnect the harness connector at the appropriate Q6 Camshaft Position Actuator Solenoid Valve.
  2. Test for 5-12 Ω between the control circuit terminal 1 and the low reference circuit terminal 2 of the Q6 Camshaft Position Actuator Solenoid Valve.
    • If not between the specified values 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If between the specified values 
  3. Test for infinite resistance between each terminal and the Q6 Camshaft Position Actuator Solenoid Valve housing.
    • If less than infinite resistance 

      Replace the Q6 Camshaft Position Actuator Solenoid Valve.

    • If infinite resistance 
  4. All OK.
scientia non olet · About LEMON Manuals