LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 3.6L (LFX) - DTC P0351 To P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0496: Evaporative Emission (EVAP) System Flow During Non-Purge >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, engine OFF.
  2. Command the EVAP Purge/Seal function to System Seal or Not Venting with a scan tool to seal the EVAP system.
  3. Start the engine.
  4. Observe the Fuel Tank Pressure Sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 V after 90 s.
    • If not within specifications 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve

    • Within Specifications 
  5. All OK
scientia non olet · About LEMON Manuals