LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Controls And Fuel - 3.6L (LFX) - DTC P0351 To P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0443, P0458, or P0459: Evaporative Emission (EVAP) Purge Solenoid Valve >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, verify DTC P0690 is not set.
    • If the DTC is not set 
  2. Verify the control circuit status parameters listed below do not display Malfunction while commanding the EVAP Purge Solenoid Valve from 0% to 50% and back to 0% with a scan tool:
    • EVAP Purge Solenoid Valve Control Circuit Open Test Status
    • EVAP Purge Solenoid Valve Control Circuit Low Voltage Test Status
    • EVAP Purge Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing

    • If Malfunction is not displayed 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing

    • If the DTC does not set 
  5. All OK.
scientia non olet · About LEMON Manuals