Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the left transmission mount (2).
- Install the left transmission mount to frame rail bolts (1) and tighten to 27 N.m (20 lb ft).
- Raise the transmission until the transmission contacts the left transmission mount.
- Install the left transmission mount to transmission bolts (1) and tighten to 50 N.m (37 lb ft).
- Remove the engine and transmission support.
- Install the battery tray. Refer to Battery Tray Replacement .
- Install the underhood electrical center.
CAUTION:
Refer to Fastener Caution .