Output Speed Sensor Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Output Speed Sensor

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the control valve lower body and upper body. Refer to Control Valve Lower Body and Upper Body Replacement .
1	Output Speed Sensor Bolt M6 x 25 CAUTION: Refer to Fastener Caution . Tighten 12 N.m (106 lb in)
2	Output Speed Sensor Procedure Perform the service programming system procedure. Refer to Service Programming System (SPS) . NOTE: After an internal transmission repair or internal part replacement the service programming system procedure should be performed.

Callout

Component Name

Preliminary Procedures

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the control valve lower body and upper body. Refer to Control Valve Lower Body and Upper Body Replacement .

Output Speed Sensor Bolt M6 x 25

CAUTION:

Tighten
12 N.m (106 lb in)

Output Speed Sensor
Procedure
Perform the service programming system procedure. Refer to Service Programming System (SPS) .

NOTE:

After an internal transmission repair or internal part replacement the service programming system procedure should be performed.