Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install a NEW control solenoid valve assembly filter plate (1).
- Install the control solenoid valve body and TCM assembly (5).
- Rotate the control solenoid valve spring (7) into position.
- Hand tighten the following fasteners.
- The 4 control valve body bolts (1) M6 x 80.
- The control valve body bolt (6) M6 x 55.
- The 3 control valve body bolts (2) M6 x 95.
- The control valve body bolt (3) M6 x 42.
- The 2 control valve body bolts (4) M6 x 65.
- Tighten the bolts (1, 2, 3, 4, 6) in the specified sequence to 12 N.m (106 lb in).
- Connect the input speed sensor electrical connector (1).
- Connect the output speed sensor electrical connector (2).
- Connect the shift position switch electrical connector (3).
- Install the control valve body cover. Refer to Control Valve Body Cover Replacement .
- If a NEW TCM has been installed into the vehicle, the NEW module needs to be reprogrammed. Refer to Service Programming System (SPS) .
- Transmission internal service/overhaul
- Valve body repair or replacement
- Control solenoid valve assembly replacement
- TCM software/calibration update
- Any service in response to a shift quality concern
- Perform the Reset Transmission Adapts. Refer to Reset Transmission Adapts .
CAUTION:
Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter plate to the control solenoid valve assembly, resulting in possible damage or contamination.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all bolts before tightening, then tighten in specified sequence.
NOTE:
The Reset Transmission Adapts procedure must be performed when one of the following repairs have been made to the vehicle. Failure to perform the procedure after one of the following repairs may result in poor transmission performance, as well as transmission DTCs being set: