Conditions for Running the DTC

P2714

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
• Ignition voltage is between 8.6-32 V.
• Output speed is 36 RPM or greater, or accelerator pedal position is 0.5 % or greater.
• Throttle position signal is valid.
• Engine speed is 400-7,500 RPM for 5 s.
• Transmission fluid temperature is -6.7°C (20°F) or greater.
• High side driver is enabled.

P2715

• DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
• Ignition voltage is 8.6-32.0 V.
• High side driver is enabled.
• Transmission fluid temperature is -6.7°C (20°F) or greater.
• Engine speed is 400-7,500 RPM for 5 s.
• Transmission output shaft speed is 36 RPM or greater, or the accelerator pedal position is 0.5 % or greater.
• Commanded and attained range is not 1st gear.