Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
Engine speed is 400-7,500 RPM for 5 s.
High side driver is enabled.
Ignition voltage is greater than 8.5 V.
Throttle position signal is valid.
Transmission fluid temperature is -6.6°C (20°F) or greater.
Output shaft speed is 36 RPM or greater, or the throttle position is 0.5 percent or greater