Fuel Feed Pipe Replacement
WARNING: This page is about a different variant/trim than selected.
Courtesy of GENERAL MOTORS COMPANY
| Callout |
Component Name |
|
Preliminary Procedures
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
- Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement
.
- Remove the fuel pipe shield. Refer to Fuel Pipe Shield Replacement .
|
| 1 |
Fitting
Tighten
- First Pass 15 N.m (11 lb ft)
- Second Pass 30 N.m (22 lb ft)
|
| 2 |
Bolt (Qty: 2)
Tighten
50 N.m(28 lb ft) |
| 3 |
Fuel Feed Pipe Procedure
- DISCARD the pipe when removed, and install a NEW pipe.
- Ensure that the high pressure fuel pipe, and fuel pump fittings are clean and dry prior to assembly.
- Pressure up the fuel system and check for leaks.
|