LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.6L (LFX) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister, Hose/Pipes & EVAP Vent Solenoid Electrical Connector
    GM1371134Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The EVAP emissions canister is located under the center of the vehicle. It has 3 EVAP line connections:

    • The EVAP fresh air
    • The EVAP vent
    • The EVAP purge
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. CAUTION:

    Clean all fuel pipe connections and surrounding areas before disconnecting the fuel pipes to avoid contamination of the fuel system.

  2. Disconnect the EVAP canister fresh air hose/pipe from the fuel tank fresh air hose/pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP canister vent hose/pipe from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: View Of Chassis Fuel Supply Line, EVAP Canister Purge Hose/Pipe & EVAP Canister-To-Underbody Nuts
    GM1371133Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the EVAP canister purge hose/pipe (1) from the EVAP canister.
  5. Remove the EVAP canister-to-underbody nuts (3).
  6. Lower the EVAP canister.
    7. Fig 3: View Of EVAP Canister, Hose/Pipes & EVAP Vent Solenoid Electrical Connector
    GM1371134Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the EVAP vent solenoid electrical connector (1).
  8. Remove the EVAP canister (4) from the vehicle.
scientia non olet · About LEMON Manuals