LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 3.6L (LFX) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister, Hose/Pipes & EVAP Vent Solenoid Electrical Connector
    GM1371134Courtesy of GENERAL MOTORS COMPANY
  1. Connect the EVAP vent solenoid electrical connector (1).
  2. Install the EVAP canister (4) to the underbody of the vehicle.
    3. Fig 2: View Of Chassis Fuel Supply Line, EVAP Canister Purge Hose/Pipe & EVAP Canister-To-Underbody Nuts
    GM1371133Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the EVAP canister-to-underbody nuts (3).

    Tighten 

    Tighten the nuts to 9 N.m (80 lb in).

  4. Connect the EVAP canister purge hose/pipe (1) to the EVAP canister.
    5. Fig 3: View Of EVAP Canister, Hose/Pipes & EVAP Vent Solenoid Electrical Connector
    GM1371134Courtesy of GENERAL MOTORS COMPANY
  5. Connect the EVAP canister vent hose/pipe (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the EVAP canister fresh air hose/pipe to the fuel tank fresh air hose/pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals