LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.6L (LFX) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Valve Stem Oil Seal Removal/Installation
    GM1338340Courtesy of GENERAL MOTORS COMPANY
  1. Use the EN-46116  remover/installer (1) in order to install the valve stem seals (2).
    2. Fig 2: Valve Spring
    GM902899Courtesy of GENERAL MOTORS COMPANY
  2. Install the valve spring.
  3. Install the valve spring retainer.
    4. Fig 3: Valve Spring Compressor Tool
    GM1338337Courtesy of GENERAL MOTORS COMPANY
  4. Install the EN-46110  compressor above the applicable valve spring as shown.

    Tighten the EN-46110  compressor nut (2).

    5. Fig 4: Valve Spring Keepers And Valve Spring Retainers
    GM902903Courtesy of GENERAL MOTORS COMPANY
  5. Install the valve spring keepers.
  6. Remove the EN-46110  compressor.
  7. Disconnect the EN-39313  adapter from the compressed air source.
  8. Remove the EN-39313  adapter.
  9. Install the spark plugs. Refer to Spark Plug Replacement .
  10. Install the rocker arms. Refer to Valve Rocker Arm Replacement - Right Side .
  11. Remove the EN-46106  tool.
  12. Install the starter motor. Refer to Starter Replacement (LFX) .
scientia non olet · About LEMON Manuals