LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 3.6L (LFX) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Camshaft Cover Bolt Grommets
    GM1306494Courtesy of GENERAL MOTORS COMPANY
  1. Install new camshaft cover bolt grommets prior to installing the camshaft cover bolts.
    2. Fig 2: Engine Front Cover Split Lines
    GM1306495Courtesy of GENERAL MOTORS COMPANY
  2. Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant, on the engine front cover split lines (1).
    3. Fig 3: Right Camshaft Cover
    GM1306496Courtesy of GENERAL MOTORS COMPANY
  3. Place the right camshaft cover into position onto the right cylinder head.
    4. Fig 4: Camshaft Cover Bolts
    GM1836415Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution

  4. Loosely install the right camshaft cover bolts.
    5. Fig 5: Right Camshaft Cover Bolt Tightening Sequence
    GM1392434Courtesy of GENERAL MOTORS COMPANY
  5. Tighten the right camshaft cover bolts in the sequence shown to 10 N.m (89 lb in).
  6. Connect and install the engine harness to the camshaft cover.
    7. Fig 6: Spark Plug Tube Seal Guides
    GM1306498Courtesy of GENERAL MOTORS COMPANY
  7. Remove the EN-46101  guide from the spark plug tubes of the right cylinder head.
  8. Install the ignition coils. Refer to Ignition Coil Replacement - Bank 1
scientia non olet · About LEMON Manuals