Valve Rocker Arm Installation - Left Side
WARNING: This page is about a different variant/trim than selected.
- Apply a liberal amount of lubricant to the pivot pocket (1), roller (2) and valve slot (3) areas of the camshaft followers. Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended lubricant.
- Place the camshaft followers in position on the valve tip and stationary hydraulic lash adjuster (SHLA).
- The rounded head end of the follower goes on the SHLA while the flat end goes on the valve tip.
- Clean the camshaft journals and carriers with a clean, lint-free cloth.
NOTE:
The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.