LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Mechanical - 3.6L (LFX) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Intake Manifold Assemble

Intake Manifold Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Plastic Compression Limiters
    GM2612732Courtesy of GENERAL MOTORS COMPANY
  1. Install the NEW plastic compression limiters (1).
    2. Fig 2: Lower Intake Manifold Gaskets
    GM2612731Courtesy of GENERAL MOTORS COMPANY
  2. Install the NEW lower intake manifold gaskets (3).
  3. Install the lower intake manifold (2) and bolts (1).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the lower intake manifold bolts (1) to 7 N.m (62 lb in).
    5. Fig 3: MAP Sensor
    GM2202059Courtesy of GENERAL MOTORS COMPANY
  5. Install the MAP sensor (2).
  6. Install the MAP sensor bolt (1) and tighten to 4 N.m (35 lb in).
    7. Fig 4: EVAP Solenoid
    GM2202058Courtesy of GENERAL MOTORS COMPANY
  7. Install the EVAP solenoid (1).
  8. Tighten the EVAP solenoid bolt to 10 N.m (89 lb in).
    9. Fig 5: Throttle Body Components
    GM2202057Courtesy of GENERAL MOTORS COMPANY
  9. Install the NEW throttle body seal (3).
  10. Install the throttle body (2).
  11. Install the throttle body bolts (1) and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals