LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Mechanical - 3.6L (LFX) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Crankshaft and Bearing Removal >> Crankshaft Bearing Removal

Crankshaft Bearing Removal

WARNING: This page is about a different variant/trim than selected.
  1. Prepare a piece of cardboard or equivalent, numbered 1-4 for bearing identification. Main bearing journals are numbered from the front of the engine.
    2. Fig 1: Thrust Bearing In Number 3 Journal
    GM1313745Courtesy of GENERAL MOTORS COMPANY
  2. Remove the crankshaft upper bearing halves from the cylinder block. Note the position of the thrust bearing (1) at the number 3 journal (2).
  3. Place the crankshaft upper bearing halves on the cardboard in the correct positions. Note that the number 3 bearing is the thrust bearing.
    4. Fig 2: Crankshaft Bearing Caps And Lower Bearing Halves
    GM902744Courtesy of GENERAL MOTORS COMPANY
  4. Remove the crankshaft lower bearing halves from the crankshaft bearing caps.
  5. Place the crankshaft lower bearing halves in the correct positions on the cardboard.
scientia non olet · About LEMON Manuals