Automatic Transmission Flex Plate Removal

Special Tools 

EN 46106  Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools .

Fig 1: Flywheel Holding Fixture
Courtesy of GENERAL MOTORS COMPANY
1. Install the EN 46106  tool through the starter mounting hole.
Fig 2: Engine Flywheel And Bolts
Courtesy of GENERAL MOTORS COMPANY
2. Remove the flex plate bolts (1) and discard.
3. Remove the flex plate (2) from the crankshaft.
Fig 3: Flywheel Holding Fixture
Courtesy of GENERAL MOTORS COMPANY
4. Remove the EN 46106  tool.