Torque Converter and Differential Housing Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Torque Converter And Differential Housing Components With Tightening Sequence

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Torque Converter Housing Outer Seal
2	Torque Converter and Support and A/Trans Fluid Pump Housing Assembly
3	Torque Converter and Differential Housing Bolts M8 x 35 (Qty: 17) CAUTION: Some bolt torques specifications are different. Over tightening the bolts at the 12, 15 and 17 positions in the sequence could cause damage to the case threads. CAUTION: Refer to Fastener Caution . Procedure: Tighten in sequence shown. Tighten Bolts 1-11, 13-14 and 16 to 36 N.m (27 lb ft) Bolts 12, 15 and 17 to 30 N.m (22 lb ft)