LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2016 >> Terrain SL, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 6T70 (M7U M7W) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Lift Plate and Holding Fixture Installation

Lift Plate and Holding Fixture Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Lift Plate And Holding Fixture
GM1737775Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Transmission Case Assembly
WARNING:

Handle with care, the transmission assembly weighs over 90.7 kg (200 lbs). Bodily injury could occur if not handled properly.

WARNING:

Lock pin must be secured into the bench fixture to hold the transmission and prevent bodily injury.

CAUTION:

Refer to Fastener Caution .

Procedure

  1. Install DT-47811-A  Lift Plate
  2. Tighten bolts and nut to 12 N.m (106 lb in)
  3. Raise the transmission with an overhead hoist in order to install the holding fixture.
  4. Adjust mounting block on DT-46625  Transmission Holding Fixture to match bosses on case, then tighten bolts to 13 N.m (10 lb ft)
  5. Ensure the DT-3289-20  Holding Fixture is mounted to a bench that is properly supported and will support the weight of the transmission assembly without tipping.
  6. Install lock pin for DT-3289-20  Holding Fixture.

Special Tools

  • DT-3289-20  Holding Fixture
  • DT-46625  Transmission Holding Fixture
  • DT-47811-A  Transmission Lift Plate

For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals