Case Cover and 3-5-Reverse and 4-5-6 Clutch Housing Removal
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | A/Trans Case Cover Assembly Bolt M6 x 30 (Qty: 10) |
| 2 | A/Trans Case Cover Assembly
CAUTION:
Use care when pulling the input speed sensor wire harness through the case to avoid damaging the harness. |
| 3 | A/Trans Case Cover Gasket
NOTE:
The gasket is not reusable. |
| 4 | Input Shaft Thrust Bearing Assembly
NOTE:
The bearing may be stuck to the case cover. |
| 5 | 3-5 Rev/4-5-6 Clutch Housing Assembly |